MINIWARE AirGo 140 Mini Heat Gun Review

More Fun Tech is back with a new upload. The review focuses on the tool's portability and power delivery in a workshop setting. The presenter outlines the device's interface and menu options.

The video puts the AirGo 140 through several practical tests. It attempts component removal from a modern multi-layer board, desolders a RAM chip from a ZX Spectrum, and shrinks tubing on wire joins. Each scenario demonstrates the gun's temperature control and airflow performance.

A precision test on a smaller SMD component assesses the gun's fine-detail capability. The reviewer also walks through the on-screen interface, highlighting menu navigation and setting adjustments. Overall, the footage provides a hands-on look at the AirGo 140's suitability for hobbyist repairs.

Watch the full review to see the AirGo 140 in action:

Comment highlights:

"Perhaps one consideration is the small hot surface area of the metal on the end. This may be less likely to burn the operator I guess." - @Karlos_Fandango1

"24:49 a bit of flux on the pins adds something to build up thermal mass around the pins. Air itself is an insulator so when you blow on the pins some of the energy is going into the IC, the pins, a..." - @tomstdenis

"(that cap you were removing) If you tin the pads with leaded solder with an iron, it should lower the melting point and make it easier for the hot air to remove it." - @tomstdenis